TRIK-L-START's "Big Brother"... Provides ample current to keep your engine starting batteries FULLY CHARGED - Even after months of storage!
Simple hook-up - Only 3 wires to connect... Works with 6 and 12 volt house batteries.
Complete Kit - Includes mounting screws, crimp-on ring terminals, illustrated installation instructions.
Entire circuit is encapsulated inside a solid block of epoxy... Almost indestructable!
Product Overview
For Gas & Diesel Engines Single or dual starting battery applications
Fully Automatic Operation Install it, and forget it!
Gentle, Tapered Charge Rate Prevents over/undercharging, minimizes water loss.
No AC Power Cord "Steals" DC power from your house battery charger - No AC wiring or extension cords required!
Safer Than AC-Powered Chargers No electric shock or fire hazards.
Powerful 15 Amp Maximum Output Easily handles even the largest dual starting battery banks.
Five Status LEDs Monitor all charging functions, warn against improper hook-up, disconnected batteries or overvoltage conditions
Low Starting Battery Alarm Built-in alarm beeps if starting batteries are in danger of overdischarge - Helps protect them from permanent damage
Overvoltage Protection Automatically shuts down during house battery equalization, resumes normal operation afterwards.
Optimizes Starting Battery Life Prevents destructive deep discharges - Pays for itself in battery savings!
Also Works With Solar Panels Perfect for camping or RV storage in areas where AC power isn't available.
Rugged, Reliable Design Protected against reverse polarity, and encapsulated in a solid block of epoxy - Shrugs off moisture, dust, grease and oil.
Quick, Easy Installation Just 3 connections to make: 1. House Battery + 2. Starting Battery + 3. Chassis Ground
Hardware & Connectors Included Includes an assortment of crimp-on ring terminals for connections to your batteries or isolator relay.
Exact Same Mounting "Footprint" as our 5-amp TRIK-L-START™ Makes an ideal high-performance upgrade in all applications where TRIK-L-START™ was previously installed.
Full 2 Year Warranty Service and technical support are just a toll-free phone call away!
Designed and Made in America
PRODUCT DESCRIPTION - AMP-L-START™ is a "smart" charger/maintainer for your engine starting batteries. Capable of supplying up to 15 continuous amps of charging current, it is the "big brother" of our popular 5-amp TRIK-L-START™ model, and can be used as an upgrade in all applications where the TRIK-L-START™ was previously used.
HOW IT WORKS - Connected between your house and engine starting batteries, AMP-L-START™ "steals" some of the charging current from your house battery charger (or solar panels) to also keep your engine starting batteries charged. Whenever no house battery charging source is present, it automatically shuts down, thereby preventing any reverse current flow back into the house batteries.
The charging current is continuously adjusted to whatever amount is necessary to recharge and maintain your starting batteries - It can vary from 0 to 15 amps, depending on the battery's state of charge. AMP-L-START™ works with single- and dual- starting battery systems, and is compatible with all battery types - Gell-Cell, AGM, "Maintenance-Free" and conventional flooded-cell.
A built-in piezo beeper sounds an audible Low Starting Battery Alarm if your starting battery voltage drops below approx. 11.9 volts. This feature helps protect your starting batteries, by warning you of a charging problem before the batteries become discharged to the point of permanent damage.
An Overvoltage Protection feature automatically shuts the unit down whenever the house battery voltage rises above approx. 14.75 volts, thereby protecting the starting batteries and electrical system from excessive voltage during house battery equalization - While this occurring, the HOUSE BAT. and STARTING BAT. indicator LEDs flash rapidly. Normal operation resumes as soon as the house batteries drop below approx. 14.5 volts.
AMP-L-START™ is designed for permanent installation, and includes everything needed for a typical installation (except wire - stranded 12 or 10 gauge is recommended). Illustrated instructions make the installation process an easy 20-minute job in most applications.
AMP-L-START™ comes with a 2-year warranty, and our toll-free lifetime technical support